Copying A Large Number Of Originals At Once (Job Build) - Sharp MX-M753 Operation Manual

COPYING A LARGE NUMBER OF
ORIGINALS AT ONCE (Job Build)
When copying a very large number of originals, this function allows you to divide the originals into sets and feed each
set through the automatic document feeder one set at a time.
Use this function when you wish to copy all of the originals as a single job but the number of originals exceeds the
maximum number that can be inserted.
This function is convenient when you wish to sort copies of a large number of originals into multiple sets. Because all
originals are copied as a single job, you are saved the trouble of sorting the copies that would be required if the originals
were divided into separate copy jobs.
When scanning originals in sets, divide the sheets so that no set has more than the number of paper that can be loaded,
and then scan from the set with the first page. The settings that you select for the first set can be used for all remaining sets.
Sorting the copies of a large number of originals into 2 sets
Originals
1
Indicator
line
1
(2)
Special Modes
Margin Shift
2
Pamphlet Copy
Covers/Inserts
Book Copy
Press the [START] key to scan the first set of originals.
Scanning begins.
3
To cancel scanning...
Press the [STOP] key (
1
101
(3)
OK
Dual Page
Erase
Copy
1
Tandem
Job
2
Build Copy
Transparency
Multi Shot
Inserts
Tab Copy Card Shot
).
Originals are
scanned in
separate sets
Insert the originals face up in the
document feeder tray.
Insert the originals all the way into the document feeder tray.
Multiple originals can be placed in the document feeder tray.
The stack of originals must not be higher than the indicator line
on the tray.
Select Job Build.
(1) Touch the [Special Modes] key.
☞
SPECIAL MODES
(2) Touch the [Job Build] key so that it is
highlighted.
(3) Touch the [OK] key.
You will return to the base screen of copy mode.
2-54
COPIER
1
1
(page 2-42)
Contents