Download Print this page

Volkswagen T-Cross 2020 Instruction Manual page 299

Advertisement

Programming the tyre control indicator
After changing the tyre pressure or after
changing one or more wheels, the tyre control
indicator needs to be reset. This also applies
after changing the wheels, e.g. front wheels for
rear wheels.
To reprogram the system, you must first reset
the saved values.
– Switch on the ignition.
– Depending on the vehicle version and the
radio version, press the button on the radio
system
p. 27.
– Open the Vehicle settings menu in the radio system.
– Touch the function button
– Touch the
function button.
SET
– If the 4 tyre pressures correspond to the
required values, touch the
button to store the tyre pressures.
After a longer driving time and at varying
speeds,
the
system
autonomous mode values and monitors them.
The tyre control indicator must be
reprogrammed under the following conditions:
– If the tyre pressure has been adjusted.
– If one or more wheels have been changed.
– If the wheels have been reversed, e.g. front
to rear
p. 287.
The tyre control indicator does not work if
ESC or ABS is faulty.
two
p. 142.
After a warning of too low tyre pressure,
switch off the engine.
and switch it on again. Only then can the tyre-
check indicator be switched on.
reprogramming.
.
Tyres
function
Confirm
reprograms
the
new
Troubleshooting
control indicator problems
Please note
at the beginning of this chapter
on page 284.
on
The pressure in one or more tyres has been
reduced or the tyre has suffered a structural
failure.
– Do not continue!
– Check all tyre pressures and adjust
290.
– Replace damaged tyres.
– Re-program the tyre control indicator
page 284.
– If the problem persists, look for a
specialised company.
flashes for about a minute a n d then lights up
permanently.
Faulty system.
– Do not continue!
– Switch the ignition off and on again.
WARNING
– Re-program the tyre control indicator
page 284.
Different tyre pressure or tyre pressure that is
too low can cause tyre collapse, loss of vehicle
– If the problem persists, look for a
control, accidents, serious injury and death.
specialised company.
● If the green indicator light comes on stop
immediately and check all tyres
● Different tyre pressure or tyre pressure that
is too low can increase tyre wear, worsen
driving stability and increase braking
distance.
● Different tyre pressure or tyre pressure
that is too low can lead to sudden tyre
collapse, causing the tyre to burst and loss
of control of the vehicle.
Wheels and tyres
tyre
page
p. 290.
285

Advertisement

loading