Finish - Spectra Logic Spectra 10000 Installation Manual

Return the library to its operating location.
1.
Warning:
The library is heavy, approximately 56 lbs.; get help when moving
the library.
Reconnect all cables to the library using the notes you recorded on page 11 and
2.
page 12.
Caution:
If the computer equipment was restarted while your library was
away, you must exit all programs and shut down all equipment
before connecting the library.
Power on all computer equipment.
3.
Start the all applications including your backup utility software.
4.
Note:
If you removed a tape from an occupied carousel slot to install a new
drive, load that tape into the library, and re-synchronize the tape
inventory.
This completes the AIT tape drive installation procedure.
Your library is now operating with the new or replaced tape drive online.
If You Have Difficulty
If you need assistance with any part of this procedure, call Spectra Logic Technical
Support at (800) 227-4637 or at (303) 449-6444, extension 3175. Please inform the
support representative that you are installing an AIT tape drive in your Spectra 10000
library.

Finish

Spectra 10000 Library AIT Tape Drive Installation Guide 27