Spectra Logic Spectra 10000 Install Manual
Gripper jaws
Hide thumbs
Also See for Spectra 10000:
- User manual (138 pages) ,
- Installation manual (27 pages) ,
- Install manual (21 pages)
Related Manuals for Spectra Logic Spectra 10000
Summary of Contents for Spectra Logic Spectra 10000
- Page 1 Gripper Jaws Replacement Guide for Spectra Logic Libraries Gripper Jaws Replacement Guide Part Number 90840098 Revision C...
- Page 2 Information furnished in this manual is believed to be accurate and reliable. However, no responsibility is assumed by Spectra Logic Corporation for its use. Due to continuing research and development, Spectra Logic Corporation may revise this publication from time to time without notice, and reserves the right to change any product specification at any time without notice.
- Page 3 (arrows point to the gripper jaw pieces) This procedure should take about one hour. You will need the replacement gripper jaws from Spectra Logic or an authorized dealer. See Figure 9 on page 8 for part numbers and mounting locations of the gripper jaws.
- Page 4 3. If necessary, move the library to a location where you have access to all sides of the library. Warning: The library is heavy, about 56 pounds. Get help when moving the library. Page 4 Gripper Jaws Replacement Guide for Spectra Logic Libraries Spectra 4000, 5000 and 5100 4mm Tape Libraries...
- Page 5 3. Remove the cover by lifting it straight up, Figure 5. 4. Set the cover off to the side and out of the way. Figure 4: Slide cover back Gripper Jaws Replacement Guide for Spectra Logic Libraries ½ inch, Figure 4. This will release the side clips...
- Page 6 Figure 7: Positions of the thumb and index finger to unlock the picker arm and push it forward. Picker arm assembly is shown removed from the library for clarity. (Barcode reader not installed.) Page 6 Gripper Jaws Replacement Guide for Spectra Logic Libraries...
- Page 7 Remove the gripper jaws from the picker arm. 2. Install the new gripper jaw on the picker arm. 3. Remove and replace the other gripper jaw. 4. Return the picker arm to its home and locked position. Gripper Jaws Replacement Guide for Spectra Logic Libraries Page 7...
- Page 8 Figure 10: Gripper jaw piece Figure 11: Gripper jaw piece Figure 12: Gripper jaw piece for 8mm libraries. for 4mm libraries. for all libraries. Part number 90847160 Part number 90840160 Part number 90840161 Page 8 Gripper Jaws Replacement Guide for Spectra Logic Libraries...
- Page 9 3. Power on all computer equipment and start all applications including your backup utility software. If you removed any tapes from the library, re-introduce those tapes into the library now. Gripper Jaws Replacement Guide for Spectra Logic Libraries Page 9...