Table of Contents
Advertisement
3. Follow the procedure listed in
Steps
Slide the PSU into the PSU bay until the PSU is fully seated and the orange release latch snaps into place.
Figure 74. Installing a power supply unit
Next steps
1. If you have unlatched or removed the cable management accessory, reinstall or relatch it. For information about the cable
management when the PSU is removed or installed while the system is in the rack, see the system's cable management
accessory documentation at
2. Connect the power cable to the PSU, and plug the cable into a power outlet.
CAUTION:
When connecting the power cable to the PSU, secure the cable to the PSU with the strap provided
on the handle.
NOTE:
When installing, hot swapping, or hot adding a new PSU, wait for 15 seconds for the system to recognize the
PSU and determine its status. The PSU redundancy may not occur until discovery is complete. Wait until the new PSU is
discovered and enabled before you remove the other PSU. The PSU status indicator turns green to signify that the PSU
is functioning properly.
3. Follow the procedure listed in
Power interposer board (PIB)
Removing the PIB
Prerequisites
1. Follow the safety guidelines listed in
2. Follow the procedure listed in
3.
Remove air
shroud.
4.
Remove the power supply
Before working on your
PowerEdge
manuals.
After working inside your
Safety
instructions.
Before working on your
unit.
system.
system.
system.
Installing and removing system components
101
Advertisement
Table of Contents
