IKONIX Associated Research HYAMP III Operation And Service Manual page 31

the "+" soft key to change the numeric value. Once you change the value it is
automatically stored.
Time
Within the Set Time parameter are three fields: hours, minutes, and Military or
Standard time. Use the "" soft key to select the field within the time parameter you
want to edit. Use the "+" soft key to change the numeric value. Once you change the
value it is automatically stored.
The Cal-Alert Warning screen appears as follows:
At the Cal-Alert Warning screen "Show screen again?" will be displayed along with the
options "Yes" or "No." The question must be answered by toggling between the words
"Yes" and "No" using the corresponding soft key and then pressing the "OK" soft key.
Selecting "No" will disable the Cal-Alert function. Selecting "Yes" will exit the Cal-Alert
Warning screen and go to the standard introduction screen without disabling the Cal-
Alert function.
If security is enabled this screen will not appear.
It is possible to quickly bypass the security of the Cal-Alert by powering up the
instrument while pressing the soft key that is second from the top of the instrument.
This will temporarily start the instrument in an unsecured state. The Cal-Alert Warning
screen will be displayed and Cal-Alert may be disabled by selecting "No" and then
pressing the "OK" soft key. This type of security override only affects the Cal-Alert
screen. It is not necessary to restart the instrument to activate the security setting.
27