IKONIX Associated Research HYAMP III Operation And Service Manual page 29

When P/F is selected, it is not possible to see the test results directly at the end of the
test. In order to review the test results refer to section 4.2.3. Reviewing Test
Results.
When Last is selected, the results of the last test step performed will be displayed on
the Perform Tests screen. There will not be a change in appearance or special
screen displayed in this mode.
Lock
Turning Lock ON restricts access to parameter and system settings. The level of
security is determined by the Mem Lock function.
Mem Lock
Mem Lock is a sub-function of the Lock setting. In order for the Mem Lock function to
work, the Lock must first be turned ON. Turning the Mem Lock OFF will allow the
user to access all available memory locations but restricts access to memory and step
editing capabilities. Turning the Mem Lock ON will allow the user to only run the
currently loaded memory.
Disabling Lock
Once the Lock function is activated, a special procedure is required to defeat the
security. To defeat the security press the top soft key while powering up the
instrument. Now you may access the system menu and turn the security function
OFF.
Hipot Start
Scroll the cursor to the Hipot Start parameter using the directional soft keys. You may
toggle the selection between GW and G + W by pressing the "+" soft key.
25