Table of Contents
Advertisement
DC Charger
IMPORTANT SAFETY INSTRUCTIONS
SAVE THESE INSTRUCTIONS
Read carefully all documentation before handling the equipment and pay special attention to safety
recommendations to maximize the performance of this product and ensure its safe use and installation.
This document covers the most important and frequent potential causes of damage to equipment or personnel.
It is the responsibility of the installer to follow the instructions provided in this manual, follow good electrical
practices, and identify all warnings and recommendations before starting up and operating the electric vehicle
chargers.
WARNING
FIRST CONSIDERATIONS
The operations detailed in this manual can only be performed by qualified personnel.
The condition of qualified personnel referred to in this manual shall be at least the condition that meets the
standards, regulations and safety laws applied to the installation and operation of this equipment.
Read and retain the Installation Manual for future reference.
Before assembling the equipment, read all instructions, caution signs and other sections of this manual. Failure
to follow these warnings can result in severe electrical shock or death. Pay attention at all times to prevent
possible accidents.
In addition to the recommendations in this manual, local and site-specific safety procedures should be
observed. Additionally, local and national electrical regulations must be followed to avoid personal injury and/or
equipment damage.
The electric vehicle charging system may cause an ELECTRICAL DISCHARGE if the warnings indicated
in this manual are not followed.
Make sure the equipment is completely disconnected from the power supply and grounded before
handling or servicing. Otherwise, there is a risk of electric shock. To avoid electrical hazards, disconnect
the input supply, ground the equipment, remove control voltages before performing any tasks, and ensure that
busbars are completely discharged. Warning and safety labels must be properly affixed to terminals, cabinets,
and control panels in accordance with local regulations.
When working on electrical installations, always remember to apply the FIVE GOLDEN RULES:
1. Visible shutdown of all live sources.
2. Mechanical lock out of all electrical services elements.
3. Verify the absence of voltage by using the appropriate tools for the voltage of the installation.
4. Ground and short-circuit all possible voltage sources.
5. Mark the working area and keep out zone.
Do not modify the equipment. If you do so, Power Electronics will not assume any liability, and the product
warranty will be voided.
Ford Pro contact info: chargingsupport@fordpro.com and 1-800-34-FLEET
NB 120 Installation Manual
8
EN
Advertisement
Table of Contents
