Table of Contents
Advertisement
DC Charger
Communications connection
Ford recommends connecting the equipment via 4G as the preferred option, Wi-Fi as the second option and
Ethernet as the last option.
Ethernet requirements (if needed)
•
Recommended cable size: Ethernet CAT 5e or CAT 6 UTP - RJ45 Connection Switch.
•
Maximum cable diameter: 7 mm (cable gland M16).
Ethernet connections:
Enter the cable inside the equipment through the cable gland. Refer to
information. Use the clamps to hold the cable and pass it to the right side of the charger.
• Once the cable is inside the equipment, pull the cable up:
o First, through the interior of the polycarbonate element located on the bottom panel, as shown in the
figure.
o Then, through the cable clamps located on the inner side part of the enclosure.
Ford Pro contact info: chargingsupport@fordpro.com and 1-800-34-FLEET
NB 120 Installation Manual
"Cable access
plate" section for further
EN
38
Advertisement
Table of Contents
