Table of Contents
Advertisement
DC Charger
12. SAFE STOP
CAUTION
The shutdown of the equipment must only be carried out by personnel qualified. Read these instructions
and all safety recommendations carefully. Otherwise, the equipment could be damaged and seriously injured
personnel.
The instructions in this manual do not replace or replace local or national regulations. It is the user's
responsibility to comply with all safety standards that apply at the installation site.
The following steps describe the process to follow for disconnecting the equipment.
Disconnect the upstream AC voltage input source and follow LOTO.
Wait for the time indicated on the protection label to avoid electrical hazards. Time for
discharge of stored energy and cooling of components. After this time and when the light
signal indicates that the voltage is no longer present, with the appropriate PPE, check both
in the plates upstream of the circuit breakers and in the plates downstream of the circuit
breakers there is not voltage.
With the appropriate PPE, check the absence of voltage at the AC input.
Ford Pro contact info: chargingsupport@fordpro.com and 1-800-34-FLEET
End the charging process if it were active.
Restrict unauthorized access to the work area.
NB 120 Installation Manual
12
52
EN
Advertisement
Table of Contents
