Table of Contents
Advertisement
DC Charger
4G Communication
For communication via 4G a MicroSIM card is pre-installed into the indicated charger control card slot:
If it is necessary to replace the MicroSIM, consult Ford for further information regarding its configuration.
The following table shows the main 4G communication characteristics:
Network mode
LTE-FDD
LTE-TDD
WCDMA
Wi-Fi communication
The communication of the equipment can be done wirelessly via Wi-Fi, it is designed to facilitate the
user's access to the charger. The equipment is compatible with both 2.4 GHz and 5GHz networks. In
case the Wi-Fi router is located at a long distance, it is advisable to choose the 2.4GHz frequency band:
The connection will be slower but more reliable. The manufacturer recommends scanning the channel
frequency bands available to set the Wi-Fi channel in the least used spectrum.
Nevertheless, it is recommended that the equipment receives the Internet connection via a physical
transmission line through the RJ-45 (Ethernet) connection, to avoid problems related to reception or
interference that may affect the signal.
Once configured, the user can start a charging session through any of the possible identification
methods.
Ford Pro contact info: chargingsupport@fordpro.com and 1-800-34-FLEET
Frequency band
B1 / B2 / B3 / B4 / B5 / B7 / B8 / B12 / B13 / B18 / B19 / B20 / B25 / B26 / B28
B38 / B39 / B40 / B41
B1 / B2 / B4 / B5 / B6 / B8 / B19
NB 120 Installation Manual
44
EN
Advertisement
Table of Contents
