Table of Contents
Advertisement
DC Charger
To access the AC connections located on the left-side of the equipment, it is necessary to open the right-side door,
which has a handle. To do this, it is necessary to unscrew three internal M8 screws and unhook the fastening
located at the height of the second screw. It is recommended to use an electric screwdriver with an extension and
a 13 mm socket bit. Use the following image as a guide.
Cable access plate
The following images show the standard cable entry plate. Only the amount of cable glands needed for the
project must be used. It is configured as follows:
• On the right side the AC connection is located. It is composed of three phases, ground wire and the neutral
wire. The plate is labeled with their identification letter so that, at the time of connection, the cables go
directly to their plates, avoiding excessive crossings and twists. For the equipment communications, two
small glands have been arranged at the top to pass the Ethernet or fiber optic cable. A blank plate is
included to suit individual site needs. Ford always recommends following the holes pattern shown below.
If this is not possible, it is customer's responsibility to meet wire bending requirements.
Ford Pro contact info: chargingsupport@fordpro.com and 1-800-34-FLEET
NB 120 Installation Manual
34
EN
Advertisement
Table of Contents
