Table of Contents
Advertisement
DC Charger
Extended storage
If the equipment is stored for an extended period of time (6 months or more) before installation, new
considerations should be taken in addition to the recommendations in the previous section "Storage":
• The equipment shall be protected under cover, by means of an external protector or by the method adapted
to the local conditions which prevents condensation and humidity inside the equipment.
• Desiccant bags shall be included inside the equipment to prevent moisture from damaging electronic
components. These shall be replaced when storage conditions require it.
• A clearance shall be left around the equipment so that inspections can be undertaken.
• Periodic inspections should be performed when possible. Proper internal cleanness must also be checked.
WARNING
Tasks shown above are standard and they are not applicable to all weather conditions. In those plants where
the installer considers extreme weather conditions, these requisites should be adjusted for each particular case,
as well as the maximum storage time for these conditions.
Unpackaging
During the unpackaging, carefully remove the packaging (do not use sharp tools). After removing the packaging,
check the material inside. If you receive replacement parts with the product, please separate and store it in a
safe place.
NOTICE
Waste disposal is installer's responsibility, and it is not within the manufacturer' scope.
Handling and transportation
CAUTION
Follow the handling and transportation requirements described here. Any other method of transport or
handling could damage the unit or void the warranty.
During handling and transport, the goods must not be exposed to moisture, overturned, inverted,
inclined, or impacted.
The elevation angle should be less than 90°.
Avoid sudden movements and jerking during lifting. Stop the load just before placing it on the ground
and then lower the equipment slowly to avoid knocks. Otherwise, the equipment may get damaged.
The equipment has a lifting tool with hoist rings located at the upper part of the tool. To lift them, slings
must be attached to each ring. Also, the slings must be firmly attached to the crane.
Ford Pro contact info: chargingsupport@fordpro.com and 1-800-34-FLEET
NB 120 Installation Manual
22
EN
Advertisement
Table of Contents
