Ford PRO NB 120 Series Installation Manual page 22

DC Charger
NOTICE
ADA regulation (ANSI A117-1 2009) specifies that user operable parts must be located at a height no greater
than 1220 mm (48 in.). provided that the project design allocates the clear access space in the front of the
charger and to each side of the charger, where the edge of the access space is not greater than 254 mm (10
in.) from the charger. Therefore, the maximum curb height must be less than 200 mm (7.9 in.).
If the layout of the access space includes an obstruction or the edge of the access space is greater than
254 mm (10 in.) from the charger, then the maximum high-reach distance to the operable components may
require to be reduced to 1170 mm (46 in.) or less. It is the responsibility of the installer to consult with local
authorities on the applicable regulation details and to provide a clear floor space in front of the charger
and to each side of the charger, and curb height, so that maximum horizontal and vertical reach
distances follow the current absolute limits.
The following picture (top view) shows an example of the layout:
Note: Front access to the connector handle can be achieved if the maximum reach is maintained to be less than
609,6 mm (24 in.) and height is less than 1168,4 mm (46 in.) although the manufacturer still recommends the
installer to leave proper access to the side of the charger.
The approximate weight for the NB 120 series is 420 kg (926 lb.)
in the following table:
CONNECTOR
CCS1
1
This is an indicative value. For other equipment of the NB 120 range, consider the weight of each power module
as of approximately 22.5 kg (496 lb.) or consult with the manufacturer.
Ford Pro contact info: chargingsupport@fordpro.com and 1-800-34-FLEET
AMPERAGE (A) LENGTH (M / FT.)
300
250
200
NB 120 Installation Manual
1
. The weight of each charging cable is detailed
WEIGHT (KG / LB.)
7.6 / 25 27.7 / 61.07
5 / 16.4 22.42 / 49.43
5 / 16.4 17.2 / 37.92
7.6 / 25
7.6 / 25 19.2 / 42.33
5 / 16.4
EN
25 / 55.12
14 / 30.86
20