Interlogix TruVision 4 IP Series Configuration Manual page 19

into your DynDNS account. The domain name displayed under "Host Name" is
that which you created on the DynDNS web site.
• ezDDNS: Enter the desired host name under "Host Name". The default host
name is utc-serial number. The new host name is registered when you click
Save.
Note: The default server address is www.tvr-ddns.net, which cannot be changed.
4. Click Save to save changes.
To define the PPPoE parameters:
1. From the menu toolbar, click
2. Check Enable PPPoE
3. Enter User Name, Password, and Confirm password for PPPoE access.
4. Click Save to save changes.
To define the SNMP parameters:
1. From the menu toolbar, click
2. Select the corresponding version of SNMP: v1, v2c or v3.
3. Configure the SNMP settings. The configuration of the SNMP software should be
the same as the settings you configure here.
4. Click Save to save changes.
Note: Before configuring SNMP, test your SNMP monitoring software and attempt to
receive the camera information via the SNMP port. By setting the Trap Address, the
camera can send the alarm event and exception messages to the SNMP monitoring
software. The SNMP version you select should be the same as that supported by the
SNMP software.
To define the 802.1x parameters:
1. From the menu toolbar, click
2. Select Enable IEEE 802.1X
3. Select EAP-PEAP
selected protocol (see table below).
Protocol
User Name
Password
PEAP version
PEAP label
TruVision Series 4 IP Camera Configuration Manual
Configuration
to enable this feature.
Configuration
Configuration
to enable the feature.
or EAP-TLS protocol, and configure all parameters for the
EAP-PEAP
This is a valid username for the 802.1x server.
This is a valid password for the username specified in the previous
field.
Version 1 or 2; affects the format of the exchange with the RADIUS
server.
This information will be available from the network administrator, as it
will differ per network.
> Network > PPPoE.
> Network > SNMP.
> Network > 802.1X. 2.
17