Table of Contents
Advertisement
HUAWEI NetEngine 8000 F
Hardware Guide
4.1.12.1.6 Installing Fiber Connectors
Installing an FC Fiber Connector
Procedure
1.
2.
3.
Issue 05 (2023-03-31)
NO TE
● After you remove the dustproof cap, ensure that the fiber pins are clean and install
them as soon as possible.
● When you disassemble fiber connectors, you must use a dedicated tool if the connectors
are densely installed. Do not pull fiber protection pipes to remove fiber connectors.
Remove the dustproof cap of the FC connector and store it for future use.
Align the core pin of the male connector with that of the female connector, as
shown in
Figure
4-144.
Figure 4-144 Aligning the male connector with the female connector
Align the male connector with the female connector and gently push the
male connector until it is completely seated in the female connector, as
shown in
Figure
4-145.
Figure 4-145 Feeding the male connector into the female connector
Copyright © Huawei Technologies Co., Ltd.
4 Hardware Installation and Parts Replacement
479
Advertisement
Table of Contents
