Table of Contents
Advertisement
HUAWEI NetEngine 8000 F
Hardware Guide
Power Cable Label
Remove the label from the backing page, and attach it to the identification plate
on the cable tie. The label should be attached to the rectangular flute on the
identification plate, and attached to only one side of the identification plate. In an
equipment room, all labels should be attached in the same way. The cable ties are
bundled at 2 cm (0.79 in.) from the connectors, and other positions are allowed in
special circumstances.
Cable ties should be bound on both ends of a cable. After the bundling, the
finished identification plate should be on top of the cable in horizontal cabling, or
on the right side of the cable in vertical cabling, as shown in
details are as follows:
●
●
Figure 4-382 Binding the label for the power cable
Issue 05 (2023-03-31)
Figure 4-381 Label for signal cables
The identification card is to the right of the cable in vertical cabling.
The identification card is on the top of the cable in horizontal cabling. Make
sure that the label is facing out.
Copyright © Huawei Technologies Co., Ltd.
4 Hardware Installation and Parts Replacement
Figure
4-382. The
708
Advertisement
Table of Contents
