Table of Contents
Advertisement
HUAWEI NetEngine 8000 F
Hardware Guide
Requirements on the Printer
To print labels, use a laser jet printer of any model. Before printing labels, set up
the page and try printing.
1.
2.
The method for adjusting the page setup is as follows.
1.
2.
3.
After the page setup has been made correctly, save it for future use. This page
setup is only necessary the first time you use the template to print the labels.
Requirements for Feeding the Printer
The label paper consists of two layers and has undergone multiple processing
procedures such as printing and cutting. No matter what model of printer you use,
feed in the labels one page at a time. To avoid jamming the labels, never use the
auto-feed mode.
Feed in the label paper in the correct direction to ensure that the text is printed in
a correct position.
Requirements for the Printed Label
Make sure that the printed labels satisfy the following requirements:
●
Issue 05 (2023-03-31)
Try printing on ordinary paper with both sides blank. Place the blank paper
over the whole page of the label paper, and check whether the page setup
conforms to the label layout.
Make sure the printer properties, such as "paper size" and "direction", have
been set correctly.
–
If the printout conforms to the sheet of labels, print the labels on the
label paper.
–
If the printout does not conform, adjust the page setup and try printing
again until the correct printout is produced.
Select File/Page Setup.
Select Layout and set Header and Footer as 0.
Select the Margins tab page. Select Left for Gutter Position and adjust the
values of Top, Bottom, Left, and Right.
NO TE
If the warning prompt as shown in
to continue the printing.
Figure 4-173 Warning prompt before printing
All the printouts must be on the label, and nothing should be printed on the
backing layer of the label page.
Copyright © Huawei Technologies Co., Ltd.
4 Hardware Installation and Parts Replacement
Figure 4-173
appears before printing, click Ignore
506
Advertisement
Table of Contents
