Huawei NetEngine 8000 F Hardware Manual page 350

HUAWEI NetEngine 8000 F
Hardware Guide
Technical Specifications
Table 3-253
Table 3-253 Breakout fibers supported
Type
Optical Cable
Parts,MPO/APC,MPO/
APC,Single mode,10m,
8 cores,GJFH-8G.
657A2,3.5mm,LSZH,
43mm Short
MPO,Bending
insensitive
Optical Cable
Assembly,MPO/APC,
4*DLC/
PC,Singlemode,GJFH
8G.657A2(LSZH),15m,
3.5mm,8 Cores,0m/1m,
2mm
Optical Cable
Parts,MPO/PC,4DLC/
PC,Multi-mode,5m,8
cores,0/1m,GJFH-8A1a.
2(OM3),3.5mm,
2mm,LSZH,43mm
Short MPO,Bending
insensitive
Issue 05 (2023-03-31)
NO TE
When using a breakout optical fiber, insert the X1 end into a 40GE QSFP+ optical module
and the X2 end into four 10GE interfaces. If the 40GE interface is Down but the four 10GE
interfaces are Up, check the 40GE interface status.
● Check whether the 40GE interface supports the breakout function. If the 40GE interface
does not support the breakout function, replace it with another interface that supports
the breakout function.
● Check whether the 40GE interface is in the breakout state. If the 40GE interface is not in
the breakout state, configure the 40GE interface to be in the breakout state.
lists the breakout fibers.
Copyright © Huawei Technologies Co., Ltd.
BOM Number
14134759
14132538
14132537
3 Hardware Description
Offi Mode
cial
Na
me
MP Single mode
O1
2-
MP
O1
2-
SM-
10
MP Single mode
O1
2-4
DLC
-
SM-
15
SS- Multimode
OP-
MP
O1
2-4*
DLC
-
M-5
339