Table of Contents
Advertisement
HUAWEI NetEngine 8000 F
Hardware Guide
2.
4.1.3 Device Installation Process
This section describes the general device installation process. Before installing
device, you need to determine the installation mode according to installation
environment. After unpacking and inspecting the device, you need to install the
chassis, boards, fibers, and cables in sequence, and then check the installation
result. After determining that the installation is correct, you can power on the
device and then check fiber connections.
Table 4-4
Issue 05 (2023-03-31)
c.
Press the spring pin with your finger and push the upper part of the door
till the spring pin properly inserts in the installation hole at the top of the
lintel.
d.
Check the spring pin and lower pins and ensure that the door is properly
installed.
e.
Follow the same steps to install the rear door.
Figure 4-33 Installing the cabinet doors
Installing the ground cables at the front doors and rear doors as shown in the
figure.
Figure 4-34 Installing the ground cables
lists the general installation process.
Copyright © Huawei Technologies Co., Ltd.
4 Hardware Installation and Parts Replacement
373
Advertisement
Table of Contents
