Table of Contents
Advertisement
HUAWEI NetEngine 8000 F
Hardware Guide
Determine the size of characters based on the number of letters or digits and
ensure that the characters are distinct and tidy.
Placement of text on a label is shown in
Figure 4-379 Placement of text on a label
Attaching Labels
After printing or writing the label, remove the label from the page and attach it to
the signal cable, or the identification plate of the power cable. The methods for
attaching labels are described in the following sections.
Label for Signal Cables
●
●
Issue 05 (2023-03-31)
Choose the place to attach labels.
The label is attached 2 cm (0.79 in.) from the connector on a signal cable. In
special cases (for example, to avoid cable bending or affecting other cables),
other positions are allowed to attach the labels. The rectangular part with
text is attached facing right or downward, as shown in
details are as follows:
–
The identification card is to the right of the cable in vertical cabling.
–
The identification card should be downward when you lay out the cable
horizontally.
Figure 4-380 Text area of the label
Procedure for attaching labels
Figure 4-381
shows the methods and procedures for attaching labels.
Copyright © Huawei Technologies Co., Ltd.
4 Hardware Installation and Parts Replacement
Figure
4-379.
Figure
4-380. The
707
Advertisement
Table of Contents
