Table of Contents
Advertisement
HUAWEI NetEngine 8000 F
Hardware Guide
4.
Installing an MTRJ Fiber Connector
Procedure
1.
2.
Issue 05 (2023-03-31)
Figure 4-360 Installed SC fiber connector
To disassemble an SC fiber connector, hold the shell of the connector (do not
hold the fiber) and gently pull the connector in the direction vertical to the
adapter. Unlock the male connector, and then separate it from the shell, as
shown in
Figure
4-361.
Figure 4-361 Disassembling an SC fiber connector
NO TICE
During operation, pinch the housing instead of the tail.
Remove the dustproof cap of the MTRJ fiber connector and store it for future
use.
Align the core pin of the male connector with that of the female connector,
make sure that the center PINs of the two connectors are on the same axis,
and the pins and card slots are in the same direction, as shown in
4-362.
Copyright © Huawei Technologies Co., Ltd.
4 Hardware Installation and Parts Replacement
Figure
693
Advertisement
Table of Contents
