Huawei NetEngine 8000 F Hardware Manual page 583

HUAWEI NetEngine 8000 F
Hardware Guide
Connecting the Chassis PGND Cable to the Cabinet
Connect the PGND cable of the device to the equipotential terminal at the rear of
the cabinet. The equipotential terminal is identified by a white flag
cabinet.
Connecting the Cabinet PGND Cable to a Ground Bar
The cabinet ground point is located at the top rear of the cabinet and identified by
the mark
equipment room through a PGND cable. Secure the PGND point using M8 screws
with a torque of 13 N•m.
Figure 4-231 Connecting PGND cables
Issue 05 (2023-03-31)
. Connect the ground point to a nearby ground bar in the
Copyright © Huawei Technologies Co., Ltd.
4 Hardware Installation and Parts Replacement
on the
572