Table of Contents
Advertisement
HUAWEI NetEngine 8000 F
Hardware Guide
6.
7.
8.
Follow-up Procedure
After replacing the power module, collect the tools. If a power module that is
replaced is confirmed to be faulty, you should fill in the Offsite Repair Card for
Faulty Materials, and send the card and the faulty power module to a Huawei
local office for timely maintenance.
4.2.11.3 Replacing the Fan Module
Issue 05 (2023-03-31)
Figure 4-274 Pull out the power module
Hold both sides of the power module and insert the module into the guide
rail of the slot. Ensure that the power module is in good contact with the
backplane of the chassis, as shown in Figure2.
Figure 4-275 Insert the power module
Connect the cables to the power module in the original sequence, and
reinstall the protective cover.
Switch on the corresponding circuit breaker on the power distribution cabinet.
Verify the functions of the new power module.
–
If the indicator on the power module panel is steady green, the power
module works normally.
–
Run the display device command on the console interface to check the
running status of the new power module. If the Status is displayed as
Normal, it indicates that the power module runs normally.
If the fan module fails to return to the normal state, you should contact a
Huawei local office for timely technical support.
Copyright © Huawei Technologies Co., Ltd.
4 Hardware Installation and Parts Replacement
629
Advertisement
Table of Contents
