Table of Contents
Advertisement
HUAWEI NetEngine 8000 F
Hardware Guide
4.1.7.1 Installing Optical Fibers
● Wear an ESD wrist strap or ESD gloves before installing optical modules.
● The bending radius of a single-mode G.657A2 optical fiber is greater than or
● Cover empty optical interfaces and idle optical modules with dust caps.
● Do not bundle optical fibers too tightly. You must be able to conveniently
● Properly fix optical fibers onto the cabinet columns to prevent impact on the
1.
2.
3.
4.
5.
Issue 05 (2023-03-31)
NO TICE
equal to 10 mm, and the bending radius of a multi-mode A1b optical fiber is
greater than or equal to 30 mm.
remove a single fiber from the bundle.
surrounding devices.
Attach temporary labels to both ends of each optical fiber.
Arrange optical fibers into a bundle and feed them through the corrugated
pipe.
Wrap adhesive tapes on both ends of the corrugated pipe to protect it from
cuts.
Route the corrugated pipe along the cable ladder.
Insert the corrugated pipe through the dedicated cable hole on the cabinet
top to the cabinet about 100 mm and tie the pipe to the cabinet.
Copyright © Huawei Technologies Co., Ltd.
4 Hardware Installation and Parts Replacement
417
Advertisement
Table of Contents
