Preparing To Install The Processor Heatsink Module (Phm) Into The Cpu Socket - Supermicro SuperWorkstation 740GP-TNRT User Manual

Preparing to Install the Processor Heatsink Module (PHM) into
the CPU Socket
After assembling the Processor Heatsink Module (PHM), you are ready to install it into the
CPU socket. To ensure the proper installation, please follow the procedures below:
1. Locate four threaded fasteners (a, b, c, d) on the CPU socket.
d
(a, b, c, d: Threaded Fasteners)
2. Locate four PEEK nuts (A, B. C. D) and four rotating wires (1, 2, 3, 4) on the heatsink
as shown in the graphics below.
A, B, C, D: PEEK Nut
1, 2, 3, 4: Rotating Wire
a, b, c, d: Threaded Fastener
PEEK Nut
(Unlatched)
3. Check the rotating wires (1, 2, 3, 4) to make sure that they are at unlatched positions as
shown in the drawing below before installing the PHM into the CPU socket.
Unlatched State
Peak Nut
Chapter 3: Maintenance and Component Installation
CPU Socket
b
c
a
d
(latched)
CPU Socket
Rotating Wire
46
Threaded Fastener
CPU Socket Pin1
b
a
Top View
Side View
Heatsink
c