Preparing To Install The Phm Into The Cpu Socket - Supermicro SuperServer SYS-741GE-TNRT User Manual

Table of Contents

Advertisement

Preparing to Install the PHM into the CPU Socket

After assembling the Processor Heatsink Module (PHM), you are ready to install it into the
CPU socket. To ensure the proper installation, please follow the procedures below.
1. Locate four threaded fasteners (marked a, b, c, d) on the CPU socket.
d
2. Locate four peek nuts (marked A, B, C, D) and four rotating wires (marked 1, 2, 3, 4) on
the heatsink as shown below.
A, B, C, D: Peek Nut
1, 2, 3, 4: Rotating Wire
a, b, c, d: Threaded Fastener
Rotating Wire
2
B
Rotating Wire
4
D
Rotating Wire
Peek Nut
b
d
(Unlatched)
(Latched)
CPU2 Socket
Chapter 3: Maintenance and Component Installation
CPU Socket
c
a
(a, b, c, d: Threaded Fasteners)
4U Heatsink (Top Side)
Rotating Wire
3
C
Rotating Wire
1
Pin 1
A
Peek Nut
c
a
Pin 1
49
b
CPU Socket Pin1
Pin 1
Rotating Wire
1
A
Rotating Wire
3
C
Pin 1
a
c
CPU1 Socket
Rotating Wire
4
D
Rotating Wire
2
B
Peek Nut
d
b

Advertisement

Table of Contents
loading

Table of Contents