Removing The Psu Backplane Unit/Operation Panel; Removing The Psu Backplane Unit - Fujitsu M10-4 Service Manual

Table 13-1 Maintenance workflow and procedures
Item Maintenance work procedure
1 Accessing a CPU memory unit
2 Removing a CPU memory unit from the
chassis
3 Removing an internal disk
4 Removing all the fan units
5 Removing a power supply unit
6

Removing the PSU backplane unit

7 Removing the operation panel
8 Installing the operation panel
9 Installing the PSU backplane unit
10 Installing a power supply unit
11 Installing all the fan units
12 Installing an internal disk
13 Installing the CPU memory unit in the
chassis
13.5 Removing the PSU Backplane
Unit/Operation Panel
13.5.1 Removing the PSU backplane unit
This section describes the procedure for removing the PSU backplane unit from the
SPARC M10-4/M10-4S. Enable the removal of the PSU backplane unit before
attempting to remove it. For details, see
Caution - Before you handle any components, wear a wrist strap to ground any static
electricity. If you perform this procedure without a wrist strap, individual
components or the overall system may be damaged. For details, see
on Static
1. Loosen the two screws in the fan slot and then remove the fan shelf.
Reference
9.5.1 Accessing a CPU memory unit
9.5.2 Removing a CPU memory unit from the chassis
10.4 Removing an Internal Disk
11.3 Removing a Fan Unit
12.3 Removing a Power Supply Unit
13.5.1 Removing the PSU backplane unit
13.5.2 Removing the operation panel
13.6.1 Installing the operation panel
13.6.2 Installing the PSU backplane unit
12.4 Installing a Power Supply Unit
11.4 Installing a Fan Unit
10.5 Installing an Internal Disk
9.10.2 Installing the CPU memory unit in the chassis
Electricity."
Chapter 13 Maintaining the PSU Backplane Unit/Operation Panel
"Chapter 7 Maintenance Flow."
"1.5 Precautions
313