7.4.2
Inactive removal
This section describes the workflows for inactive/hot and inactive/cold FRU removal.
References to detailed descriptions are written in the workflow. See any of them as
required. You can perform inactive removal work only for a system with a building
block configuration.
Inactive removal has the following patterns:
Inactive/hot removal (for an internal disk or PCIe card)
■
Inactive/cold removal (building block configuration only)
■
Inactive/hot removal (for an internal disk or PCIe card)
Inactive/hot removal can be performed on an internal disk and a PCIe card. Perform
the following procedure to remove the unit.
186
Fujitsu M10-4/Fujitsu M10-4S/SPARC M10-4/SPARC M10-4S Service Manual ・ June 2023