Confirming The Types Of Cable; Types Of Cable - Fujitsu M10-4 Service Manual

Figure 2-17 Locations of internal disk LEDs
READY
CHECK
Table 2-17 LEDs on the internal disk and their states
Name
READY
CHECK
2.5

Confirming the Types of Cable

This section describes the types of cables that connect SPARC M10-4S units to each
other or a crossbar box to the SPARC M10-4S and the locations of the ports.
The types and number of the cables to be used vary depending on the configuration.
2.5.1

Types of cable

In a building block configuration, the following cables are used for making a
connection between the SPARC M10-4S systems and between the SPARC M10-4S
and the crossbar box:
Crossbar cable
■
In a building block configuration, this is used to connect the SPARC M10-4S units
to each other or to connect the SPARC M10-4S to a crossbar box.
Color State
Green Blinking
Off
Amber On
Blinking
Off
Chapter 2 Understanding the System Components
Description
Indicates that the disk is being accessed. This
LED is normally on, but it blinks while the
disk is being accessed.
While the LED is blinking, maintenance such
as removal of the disk cannot be performed.
Indicates that maintenance such as removal
of the disk can be performed.
Indicates that an error has occurred.
Indicates that the component requires
maintenance.
(This function is also referred to as the locator.)
Indicates the normal state.
31