Fujitsu M10-4 Service Manual page 304

The version matching takes about 50 minutes.
If the above message appears, execute the showlogs monitor, and check for the
"XCP firmware version synchronization completed" message. The message
indicates the completion of XCP firmware matching. Then, perform the work
below.
XSCF> showlogs monitor
Jul 7 14:51:43 SPARCM10 Event: SCF:XCP firmware version synchronization
started
Jul 7 14:51:43 SPARCM10 Event: SCF:XSCF firmware update is started (BB#00)
Jul 7 14:51:43 SPARCM10 Information:/BB#00/CMUL:SCF:SCF Diagnosis initialize
RTC (*1)
Jul 7 14:51:43 SPARCM10 Alarm: :SCF:Gaps between BB-ID (*2)
Jul 7 14:51:44 SPARCM10 Event: SCF:XSCF ready
Jul 7 15:28:25 SPARCM10 Event: SCF:Standby XSCF Ready(BB#00)
:
Jul 7 15:40:17 SPARCM10 Event: SCF:XSCF update has been completed (BBID=0,
bank=0)
Jul 7 15:40:18 SPARCM10 Event: SCF:XCP update has been completed (XCP
version=2362:last version=2360)
Jul 7 15:40:18 SPARCM10 Event: SCF:XSCF firmware update has been completed
(BB#00)
Jul 7 15:40:18 SPARCM10 Event: SCF:XCP firmware version synchronization
completed
*1 If the "SCF:SCF Diagnosis initialize RTC" message appears, ignore the message.
*2 If the "SCF:Gaps between BB-ID" message appears, ignore the message.
2. Execute the version command to check the firmware version on all SPARC
M10-4S units.
The versions of all the XCP firmware are displayed.
In a building block configuration, you can check the Master/Standby versions.
Confirm that the XCP firmware version on each SPARC M10-4S unit is the same
as the master XSCF version.
If they are the same, steps 3 and later are not necessary. If they are not the same,
perform steps 3 and later.
XSCF> version -c xcp
BB#00-XSCF#0 (Master)
XCP0 (Current): xxxx
XCP1 (Reserve): xxxx
BB#01-XSCF#0 (Standby)
XCP0 (Current): xxxx
XCP1 (Reserve): xxxx
BB#02-XSCF#0
XCP0 (Current): xxxx
XCP1 (Reserve): xxxx
BB#03-XSCF#0
XCP0 (Reserve): xxxx
290 Fujitsu M10-4/Fujitsu M10-4S/SPARC M10-4/SPARC M10-4S Service Manual ･ June 2023