Fujitsu M10-4 Service Manual page 190

Table 7-21 System-stopped/hot addition work procedure (for an internal disk or PCIe card)
Item Work procedure
1 Opening the rack door
2 Switching the mode switch on the
operation panel to Service mode
3 Checking the operating condition
of the system and the I/O device
usage status
4 Stopping the system
5 Lowering the cable support for
maintenance on a PCIe card
6 Installing the target FRU
7 Securing the cable support after
maintenance on a PCIe card
8 Diagnosing the installed FRU
9 Confirming that there is no
problem with the installed FRU
10 Returning the mode switch on the
operation panel to Locked mode
11 Starting the system
12 Closing the rack door
176 Fujitsu M10-4/Fujitsu M10-4S/SPARC M10-4/SPARC M10-4S Service Manual ･ June 2023
Reference
"5.2 Switching the Mode Switch to Service
"5.3 Checking the Operating Condition and Resource Usage
"5.6 Stopping the Entire
"5.9.2 Lowering the cable
See the installation procedures for each FRU.
"8.3 FRU Removal and Installation
"10.3 FRU Removal and Installation
"6.1.2 Fixing the cable support"
"6.3.1 Diagnosing the system
"6.3.3 Checking the FRU status after
"6.6 Returning the Mode Switch to Locked
"6.8 Starting the Entire System"
Mode"
System"
support"
Flow"
Flow"
board"
maintenance"
Mode"
Status"