Checking The Xcp Firmware Version (Building Block Configuration) - Fujitsu M10-4 Service Manual

XSCF> flashupdate -c update -m xcp -f -s 2362
The XSCF will be reset. Continue? [y|n] : y
XCP update is started. [3600sec]
0..... 30..... 60..... 90.....120.....150.....180.....210.....240.....
270.....300.....330.....360.....390.....420.....450.....480.....510.....
4. Execute the showlogs monitor command, and check for the "XCP update has
been completed" message. The displayed message indicates the completion
of the XCP firmware update.
XSCF> showlogs monitor
Mar 15 15:29:34 M10-4-0 Event: SCF:XCP update is started (XCP version=2362:
last version=2360)
:
Mar 15 16:08:31 M10-4-0 Event: SCF:XCP update has been completed (XCP
version=2362: last version=2360)
5. Execute the version command, and confirm that the XCP firmware version is
correct.
XSCF> version -c xcp
BB#00-XSCF#0 (Master)
XCP0 (Current): xxxx
XCP1 (Reserve): xxxx
9.12 Checking the XCP Firmware Version
(Building Block Configuration)
This section describes the procedure for checking the XCP firmware version after
maintenance work on the CPU memory unit lower.
In a SPARC M10-4S building block configuration, the version must match the XCP
version on each chassis.
1. Log in to the XSCF, and confirm that the XCP firmware version is the same as
before replacement of the CPU memory unit lower.
If the XCP firmware version is different between the maintenance part and the
existing system, the message "XSCF firmware update now in progress. BB#xx,
please wait for XSCF firmware update complete." appears at login to the XSCF.
Then, the XCP firmware version will be automatically matched.
Password: *****
XSCF firmware update now in progress. BB#00,
please wait for XSCF firmware update complete.
XSCF>
Chapter 9 Maintaining the CPU Memory Unit/Memory 289