Figure 14-7 Removing the crossbar cables (optical)
2.
Remove the two crossbar cables from the other chassis.
Remove each crossbar cable by holding the tab of the cable and pulling it
straight out in the direction of the arrow. At this time, do not hold the cable part
when pulling out the crossbar cable. Pulling the cable part without the connector
lock completely released may cause damage.
Caution - Pulling the cable part without the connector lock completely released may
cause damage.
Note - There is no problem if you remove the crossbar cables from the crossbar box while
electricity is supplied.
Note - The cables at the rear of the crossbar box are bundled together and fastened to the
right-hand cable support with a hook-and-loop fastener. Therefore, to remove the crossbar
cables, remove the hook-and-loop fastener from the cable support.
Chapter 14 Maintaining the Crossbar Cables
325