Figure 6-6 Installing the front cover
Note - Check that the front cover is firmly attached and fixed.
6.2
Incorporating a SPARC M10-4/
M10-4S FRU into the System with the
replacefru Command
The FRUs subject to the operation described here are as follows:
Incorporation of the SPARC M10-4S chassis (possible only in a system with a
■
building block configuration)
Incorporation of the power supply unit and fan unit of the SPARC M10-4/M10-4S
■
6.2.1
Incorporation of the SPARC M10-4S chassis
(possible only in a system with a building block
configuration)
This section describes the procedure for incorporating a FRU into the system after
110
Fujitsu M10-4/Fujitsu M10-4S/SPARC M10-4/SPARC M10-4S Service Manual ・ June 2023