Releasing A Chassis Requiring Maintenance From The Physical; Partition - Fujitsu M10-4 Service Manual

# cfgadm -c unconfigure <Ap_Id>
Execute the cfgadm command to confirm that the internal disk requiring
4.
maintenance is disconnected.
The disconnected internal disk is displayed as "unconfigured."
# cfgadm -al
Ap_Id
<Omitted>
c2
c2::dsk/c2t50000394281B4D9Ad0 disk
c2::es/ses0
c2::smp/expd0
c3
c4
c5
c6
c7
<Omitted>
5. Execute the cfgadm command to identify the location of the internal disk
requiring maintenance by causing the CHECK LED of the disk to blink.
Enter the Ap_ID you noted in advance.
# cfgadm -x led=fault,mode=blink <Ap_ID>
6. Check the following LEDs to determine whether the internal disk requiring
maintenance can be removed:
- READY LED (green) of the internal disk: On
- CHECK LED (amber) of the internal disk: Blinking
5.4.3 Releasing a chassis requiring maintenance from
the physical partition
This section describes the procedure for releasing a chassis requiring maintenance by
using dynamic reconfiguration (PPAR DR) for the physical partition. The procedure
described here is applicable only to a system with a building block configuration.
Note - For the versions of XCP and Oracle VM Server for SPARC/SRU that support dynamic
reconfiguration (PPAR DR) of a physical partition, see the latest Product Notes.
Note - To use the dynamic reconfiguration (PPAR DR) function for physical partitions, you
need configure the logical domains in advance according to "2.5 Dynamic Reconfiguration
Conditions and Settings" in the Fujitsu SPARC M12 and Fujitsu M10/SPARC M10 Domain
Configuration Guide.
Type Receptacle Occupant
scsi-sas connected configured
connected unconfigured unknown
ESI connected configured
smp connected configured
scsi-sas connected unconfigured unknown
scsi-sas connected unconfigured unknown
fc connected unconfigured unknown
fc connected unconfigured unknown
scsi-sas connected unconfigured unknown
Chapter 5 Preparations Required for Maintenance
Condition
unknown
unknown
unknown
85