Fujitsu M10-4 Service Manual page 153

Active/hot replacement (for an internal disk in a RAID configuration)
Active/hot replacement can be performed on an internal disk. If the internal disk is in
a RAID configuration, perform the following procedure to replace it.
Figure 7-3 Active/hot replacement flow (for an internal disk in a RAID
1. Open rack door
2. Identify faulty internal disk
3. Replace internal disk
4. Incorporate replacement internal disk into system
5. Confirm that there is no problem with
replacement FRU
6. Close rack door
Table 7-4 Active/hot replacement work procedure (for an internal disk in a RAID configuration)
Item Work procedure
1 Opening the rack door
2 Identifying a faulty internal disk
3 Replacing a faulty internal disk
4 Incorporating the replacement internal disk
into the system
5 Confirming that there is no problem with
the replacement FRU
6 Closing the rack door
configuration)
Maintenance complete
Reference
"14.2.9 Checking for a Failed Disk Drive" in the Fujitsu
SPARC M12 and Fujitsu M10/SPARC M10 System Operation
and Administration Guide
"Chapter 10 Maintaining the Internal
"14.2.10 Replacing a Failed Disk Drive" in the Fujitsu
SPARC M12 and Fujitsu M10/SPARC M10 System Operation
and Administration Guide
"6.3.3 Checking the FRU status after
Disks"
maintenance"
Chapter 7 Maintenance Flow 139