Fujitsu M10-4 Service Manual page 154

Active/hot replacement (for an internal disk not in a RAID configuration)
Active/hot replacement can be performed on an internal disk. If the internal disk is
not in a RAID configuration, perform the following procedure to replace it.
Figure 7-4 Active/hot replacement flow (for an internal disk not in a RAID
1. Open rack door
2. Check operating condition of system and I/O
device usage status
3. Release faulty internal disk from system
4. Replace faulty internal disk
5. Incorporate replacement internal disk into system
6. Confirm that there is no problem with
replacement FRU
7. Close rack door
Table 7-5 Active/hot replacement work procedure (for an internal disk not in a RAID configuration)
Item Work procedure
1 Opening the rack door
2 Checking the operating condition of the
system and the I/O device usage status
3 Releasing a faulty internal disk from the
system
4 Replacing a faulty internal disk
5 Incorporating the replacement internal disk
6 Confirming that there is no problem with
the replacement FRU
7 Closing the rack door
140 Fujitsu M10-4/Fujitsu M10-4S/SPARC M10-4/SPARC M10-4S Service Manual ･ June 2023
configuration)
Maintenance complete
Reference
"5.3 Checking the Operating Condition and Resource
Usage Status"
"Enabling the removal of an internal
Enabling the removal of an I/O
"Chapter 10 Maintaining the Internal
"6.5.2 Incorporating an I/O
"6.3.3 Checking the FRU status after
disk" in "5.4.2
device"
Disks"
device"
maintenance"