Checking The Xcp Firmware Version - Fujitsu M10-4 Service Manual

starting maintenance.
The FRU installation work is completed. See
continue maintenance work.
9.11

Checking the XCP Firmware Version

This section describes the procedure for checking the XCP firmware version after
maintenance work on the CPU memory unit lower.
The XCP firmware version may be different from that before replacement of the CPU
memory unit lower. It must match the pre-replacement version.
1. Log in to the XSCF, and confirm that the XCP firmware version is the same as
before replacement of the CPU memory unit lower.
If "XCP version of XSCF and Back-Panel mismatched!" is displayed at login to
the XSCF, perform steps 2 and later to match the XCP firmware version because
the version is not the same after replacement of the CPU memory unit lower.
If it is not displayed, no work to match the pre-replacement version is necessary.
Proceed to step 5.
password: *****
XCP version of XSCF and Back-Panel mismatched!
XSCF=XCP2360, Back-Panel=XCP2362.
XSCF>
If the XCP firmware version is not the same, execute the getflashimage -l
2.
command to check whether the XCP image file of the version before
replacement of the CPU memory unit lower is saved on the replacement CPU
memory unit lower.
If not saved, import the XCP image file.
The following example imports the XCP image file of the version before XSCFU
replacement.
XSCF> getflashimage -l
Existing versions:
Version
BBXCP2360.tar.gz
XSCF> getflashimage file:///media/usb_msd/xxxx/BBXCP2362.tar.gz
If the XCP firmware version is different from that before replacement of the
3.
CPU memory unit lower, execute the flashupdate -c update command to
match the version.
The XCP firmware version will be matched to the Back-Panel version (the
version before replacement of the CPU memory unit lower).
288 Fujitsu M10-4/Fujitsu M10-4S/SPARC M10-4/SPARC M10-4S Service Manual ･ June 2023
Size Date
101544408 Thu Aug 06 08:54:02 JST 2020
"Chapter 7 Maintenance Flow" to