Removing Pci-Express And Pci-X Cards - Fujitsu SPARC Enterprise T2000 Service Manual

Section 5.2.11, "Removing the LED Board" on page 5-32
■
"Replacing the LED Board" on page 5-33
Section 5.2.13, "Removing the Fan Power Board" on page 5-34
■
"Replacing the Fan Power Board" on page 5-34
Section 5.2.15, "Removing the Front I/O Board" on page 5-35
■
"Replacing the Front I/O Board" on page 5-36
Section 5.2.17, "Removing the DVD Drive" on page 5-37
■
"Replacing the DVD Drive" on page 5-37
Section 5.2.19, "Removing the SAS Disk Backplane" on page 5-37
■
Section 5.2.20, "Replacing the SAS Disk Backplane" on page 5-38
Section 5.2.21, "Removing the Battery on the System Controller" on page 5-40
■
Section 5.2.22, "Replacing the Battery on the System Controller" on page 5-40
To locate these FRUs, refer to
5.2.1

Removing PCI-Express and PCI-X Cards

1. Perform the procedures described in
Replacement" on page
2. Locate the PCI card that you want to remove.
To locate the PCI card slots, refer to
located on the I/O portion of the motherboard assembly.
FIGURE 5-5
3. Note where the PCI card is installed, and note any cables so you know where to
reinstall the card and cables.
Appendix
5-1.
Location of PCI-Express and PCI-X Card Slots
A.
Section 5.1, "Common Procedures for Parts
and
FIGURE 5-5 FIGURE 5-6
PCI-E slots
Chapter 5 Replacing Cold-Swappable FRUs
and Section 5.2.12,
and Section 5.2.14,
and Section 5.2.16,
and Section 5.2.18,
and
and
. The PCI card slots are
PCI-X slots
5-9