Mitsubishi Electric FR-E720-0.1KNC Instruction Manual page 171

Function assignment of external terminals and CC-Link communication virtual terminals
Setting
Signal
Positive Negative
logic logic
64 164 Y64
68 168 EV
80 180 SAFE
81 181 SAFE2 Safety monitor output 2
90 190 Y90
91 191 Y91
93 193 Y93
95 195 Y95
96 196 REM
98 198 LF
99 199 ALM
9999 —
∗ Note that when the frequency setting is varied using an analog signal or
alternate ON and OFF depending on that varying speed and the timing of the varying speed due to acceleration/deceleration time setting.
(The output will not alternate ON and OFF when the acceleration/deceleration time setting is "0s".)
REMARKS
The same function may be set to more than one terminal.
When the function is executed, the terminal conducts at the setting of any of "0 to 99", and does not conduct at the setting of
any of "100 to 199".
NOTE
Changing the assignment of the terminal Y0 or a virtual terminal of CC-Link communication with one of Pr. 190 to Pr.
192, and Pr. 313 to Pr. 315 (output terminal function selection) may affect other functions. Set parameters after confirming
the function of the terminal Y0 and virtual terminals.
168
Function
During retry Output during retry processing.
24V external power The signal is output while the main circuit power supply is
supply operation off and the 24V power is supplied externally.
Safety monitor output Output while safety stop function is activated.
The signal is output when no internal safety circuit failure
(E.SAF, E.6, E.7, E.CPU) exists.
Output when any of the control circuit capacitor, main
Life alarm circuit capacitor and inrush current limit circuit or the
cooling fan approaches the end of its service life.
Fault output 3 Output when a fault occurs due to the internal circuit failure
(power-off signal) of the inverter wiring mistake.
Average current value and maintenance timer value are
Current average value
output as pulses.
monitor signal
The signal can not be set in Pr. 192 RX7 function selection .
Maintenance timer
Output when Pr. 503 rises to or above the Pr. 504 setting.
signal
Remote output Output to the terminal when a value is set to the parameter.
Output when an alarm (fan failure or communication error
Alarm output
warning) occurs.
Output when the fault occurs.
Fault output
The signal output is stopped when the fault is reset.
No function
Operation
—
of the operation panel, the output of the SU (up to frequency) signal may
Refer
Related
to
Parameter
Page
Pr. 65 to
188
Pr. 69
— —
—
24
—
24
Pr. 255 to
214
Pr. 259
— 170
Pr. 555 to
218
Pr. 557
Pr. 503,
217
Pr. 504
Pr. 495,
174
Pr. 496
Pr. 244, 107,
Pr. 500 213
—
170
— —