Connection Cable And Plug - Mitsubishi Electric FR-E720-0.1KNC Instruction Manual

4.3.3

Connection cable and plug

In the CC-Link system, use CC-Link dedicated cables.
If the cable used is other than the CC-Link dedicated cable, the performance of the CC-Link system is not guaranteed.
For the specifications of the CC-Link dedicated cable, refer to the website of the CC-Link Partner Association.
Website of the CC-Link Partner Association http://www.cc-link.org/
One-touch communication connector plug (as of December 2009)
Refer to the following table for the plug required to fabricate a cable on your own.
Model
A6CON-L5P
35505-6000-B0M GF
(1) Cable-end treatment
Apply the following treatment to the CC-Link dedicated cable that is inserted to a one-touch communication connector plug.
1. Cut the sheath
3. Cut the aluminum tape and braid.
REMARKS
Where possible, round the cable tip that is cut off with a tool such as nippers. If the cable is not rounded, it may get caught in
the middle of a plug, without fully entering into the plug.
If required, apply an insulation treatment to the shielding wire area where it is not covered by the one-touch communication
connector plug.
(2) Plug cover check
Check that a plug cover is snapped into a plug
Note
Do not push the plug cover onto the plug before inserting a cable. Once crimped, the plug cover cannot be reused.
(3) Cable insertion
Lift up the tail of the plug cover, and fully insert a cable. Insert
different signal wires to the one-touch communication connector
plug as shown in the right figure.
REMARKS
Insert the cable fully. Failure to do so may cause a crimping failure.
A cable sometimes comes out of the head of the cover.
In that case, pull the cable a little so that the cable stays under the plug cover.
Manufacturer
Mitsubishi Electric Corporation
Sumitomo 3M Limited
2. Separate shielding wires from the drain wire. Cut the shielding
wires.
4. Straighten the drain wire and twist it from the root.
(Twist seven times or more per 3cm.)
DA (Blue)
DB (White)
DG (Yellow)
Drain wire
Wiring for CC-Link communication
Shielding wires
DA (Blue)
DB (White)
DG (Yellow)
Drain wire (AWG20)
3cm
Plug
Drain wire
4
Plug cover
5 4 3 2 1
Signal name
DA (Blue)
DB (White)
DG (Yellow)
NC
SLD
51