Table of Contents
Advertisement
(3)
How to restart the motor stopped by
method)
Speed
Operation panel
STF
ON
(STR) OFF
Stop/restart example for Network operation
The motor can be also restarted by resetting the power or transmitting a reset command via CC-Link communication.
REMARKS
If Pr. 250 Stop selection is set to other than "9999" to select coasting to a stop, the motor will not be coasted to a stop but
decelerated to a stop by the PU stop function during CC-Link communication operation.
Do not reset the inverter while the start signal is being input.
Otherwise, the motor will start instantly after resetting, leading to potentially hazardous conditions.
Parameters referred to
Pr. 250 Stop selection
Misoperation prevention and parameter setting restriction
input in the Network operation mode (PU stop (PS) reset
Time
Key
Key
CAUTION
Refer to page 157
1)After completion of deceleration to a stop, switch OFF the
STF or STR signal.
2)Press
to display
3)Press
to return to
4)Switch ON the STF or STR signal.
. .............. (
reset)
.
195
5
Advertisement
Table of Contents
