Product Checking And Parts Identification - Mitsubishi Electric FR-E720-0.1KNC Instruction Manual

Product checking and parts identification

1.1 Product checking and parts identification
Unpack the inverter and check the capacity plate on the front cover and the rating plate on the inverter side face to ensure that
the product agrees with your order and the inverter is intact.
Inverter model
FR -
No. Voltage class
Three-phase 200V class
E720
Three-phase 400V class
E740
E720S Single-phase 200V class
Operation panel
(Refer to page 80)
Terminating resistor selection
switch (SW1)
(Refer to page 50)
CC-Link communication connector
(2-port type)
(Refer to page 52)
Front cover
(Refer to page 5)
Capacity plate *
∗ Location of the capacity plate and the rating plate differs
according to the inverter capacity.
Refer to the outline dimension drawing. (Refer to page 269)
• Accessory
· P-clip (for M4 screw)
Use this to ground (earth) the CC-Link dedicated cable. (Refer to page 52)
· Fan cover fixing screws (M3 × 35mm)
These screws are necessary for compliance with the EU Directive (Refer to the Instruction Manual (Basic))
FR-E720-1.5KNC to 3.7KNC, FR-E740-1.5KNC to 3.7KNC, FR-E720S-0.75KNC to 2.2KNC
FR-E720-5.5KNC to 15KNC, FR-E740-5.5KNC to 15KNC
REMARKS
For how to find the SERIAL number, refer to page 275.
2
-
E740 2.2 KNC
Represents the
inverter capacity [kW]
Inverter model
Serial number
Capacity
Cooling fan
(Refer to page 255)
Combed shaped wiring
cover
(Refer to page 7)
Rating plate *
Inverter model
Input rating
Output rating
Serial number
USB connector
(mini-B connector)
(Refer to page 220)
LED (operation status
indicator)
(Refer to page 75)
Switch for manufacturer
setting (SW2)
Do not change the initial
setting (OFF).
Standard control circuit
terminal block
(Refer to page 20)
Main circuit
terminal block
(Refer to page 15)
NC
Quantity
1
2