Table of Contents
Advertisement
ELECTRICAL COMPONENTS – SUBARU EX40
SOLENOID
See General Warnings on page 1-2.
TESTING THE SOLENOID
See Test Procedure 8 – Solenoid on page 18-27.
SOLENOID REMOVAL
1.
Disconnect battery and spark plug wire(s). See Side-Post Battery: Disconnecting the Battery-Gasoline
Vehicles on page 1-3.
See Top-Post Battery: Disconnecting the Battery- Gasoline Vehicles on page 1-4.
2.
Disconnect all the wires from the solenoid.
3.
Remove the two screws securing the solenoid in place.
4.
Remove the solenoid.
SOLENOID INSTALLATION
1.
Install the solenoid in the vehicle. Use two screws to secure the solenoid and tighten to 14 in·lb (1.6 N·m).
2.
Connect the ring terminal with the 10-gauge white wire and the 16-gauge red wire on a large post on the solenoid.
See Wiring Diagrams on page 18-8.
3.
Connect the ring terminal with the two 10-gauge red wires to the other large post on the solenoid. See Wiring
Diagrams on page 18-8.
4.
Connect the 16-gauge blue wire from the main harness to a small post on the solenoid.
5.
Connect the 16-gauge orange wire from the main harness to the other small post on the solenoid. See Wiring
Diagrams on page 18-8.
6.
Tighten the hex nuts on the large solenoid posts to 55 in·lb (6.2 N·m). Tighten the nuts on the small solenoid
posts to 22 in·lb (2.5 N·m).
7.
Connect battery and spark plug wire(s). See Side-Post Battery: Connecting the Battery-Gasoline Vehicles
on page 1-3.
See Top-Post Battery: Connecting the Battery- Gasoline Vehicles on page 1-4.
2016 Precedent Golf Car Maintenance and Service Manual
19
Solenoid
Page 19-23
Advertisement
Table of Contents
Troubleshooting
