Table of Contents
Advertisement
BATTERY CHARGER: FOR ERIC CHARGING
SYSTEM
2
4
5
7
2793
Figure 15-13 Terminal Block Cover, DC Cord and Strain
Relief – Onboard Charger
DC CORD AND STRAIN RELIEF REMOVAL
1.
Disconnect AC cord from AC outlet.
2.
Disconnect DC cord (1) at connector mounted under seat (Figure 15-13, Page 15-25).
3.
Remove terminal block cover. See Terminal Block Cover Removal on page 15-24.
4.
Remove two torx screws (4) securing strain relief (5) to terminal block (3) (Figure 15-13, Page 15-25).
5.
Remove torx screw (6) securing each DC cord wire to terminal block (3).
DC CORD AND STRAIN RELIEF INSTALLATION
1.
Attach DC cord red wire to positive terminal (+) and black wire to negative terminal (–) with torx screws (6) (Figure
15-13, Page 15-25). See following NOTE. Tighten screws (6) to 39.8 in·lb (4.5 N·m).
NOTE: The positive symbol (+) and negative symbol (–) are molded into the terminal block for easy identification.
2.
With DC cord (1) seated properly in the terminal block (3), place strain relief (5) over cord and secure with two
torx screws (4). Tighten screws (4) to 7.5 in·lb (0.85 N·m).
3.
Install terminal block cover. See Terminal Block Cover Installation on page 15-24.
DC CHARGING HARNESS REMOVAL
1.
If connected, disconnect AC cord from AC outlet.
2.
Disconnect the batteries and discharge the controller. See Disconnecting the Batteries – Electric Vehicles
on page 1-5.
1
6
3
2016 Precedent Golf Car Maintenance and Service Manual
Onboard Charger Repairs
Page 15-25
15
Advertisement
Table of Contents
Troubleshooting
