Club Car Precedent 2016 Maintenance And Service Manual page 309

TROUBLESHOOTING AND ELECTRICAL
SYSTEM – SUBARU EX40
TEST PROCEDURE 20 – Fuel Pump
See General Warnings on page 1-2.
WARNING
• To avoid the possibility of fire or explosion, make sure the fuel tank cap is securely in place while
performing this test procedure.
NOTE: This is a voltage and resistance test.
WIRE FUNCTION
1. Fuel Pump Positive (+)
2. Fuel Pump Negative (–)
3. Sending Unit Positive (+)
4. Sending Unit Negative
(–) Black Wire
3031
Figure 18-18 Fuel Pump Module Terminals
Voltage to Pump
1. If necessary, see Testing Basics on page 18-14.
2. Disconnect the 5-pin connector from the top of the fuel pump module.
3. Check that battery voltage is present between ground and the red wire of the 5-pin connector immediately after
the key switch is placed in the ON position.
NOTE: The fuel pump and low oil warning light operate for a few seconds when key switch is turned to the ON
position; it stops if no engine RPM is detected by the ECU.
4. If no voltage, check key switch. See Key Switch (Start Circuit) on page 18-24.
Pump
1. If necessary, see Testing Basics on page 18-14.
2. Disconnect battery. See Side-Post Battery: Disconnecting the Battery-Gasoline Vehicles on page 1-3.
See Top-Post Battery: Disconnecting the Battery- Gasoline Vehicles on page 1-4.
1
WIRE COLOR
Red Wire
Black/White Wire
Orange Wire
Black Wire
2016 Precedent Golf Car Maintenance and Service Manual
18
Test Procedures
Page 18-37