Table of Contents
Advertisement
TRANSAXLE, FUJI ED65 (FOR SUBARU EX40)
TRANSAXLE REMOVAL
See General Warnings on page 1-2.
1.
Turn the key switch to the OFF position and remove the key, and place the Forward/Reverse handle in the
NEUTRAL position.
2.
Disconnect battery and spark plug wire(s). See Side-Post Battery: Disconnecting the Battery-Gasoline
Vehicles on page 1-3.
See Top-Post Battery: Disconnecting the Battery- Gasoline Vehicles on page 1-4.
3.
Place chocks at the front wheels and loosen lug nuts on both rear wheels.
4.
Disconnect air intake hose, vent hose, and fuel line from throttle body and accelerator cable from electrical
component box. See Fuel System – Subaru EX40, Section 21, Page 21-1.
5.
Disconnect gray 18-pin connector from ECU.
6.
Disconnect engine ground cable lead from main wire harness.
7.
Pedal-Start Vehicles Only: Disconnect 3-wire plug from limit switch on transaxle.
8.
Disconnect three wires of main wire harness from starter/generator (Figure 19-13, Page 19-12).
9.
Loosen jam nuts (1) securing shifter cable (2) to FNR/accelerator cable mounting bracket. Then, remove bowtie
clip (3) to disconnect shifter cable end (4) from transaxle shift lever (5) and set shifter cable (2) aside (Figure
24-15, Page 24-13).
10.
Remove bolts (1) securing governor cable bracket (2) and FNR/accelerator cable bracket (3) to transaxle (Figure
24-6, Page 24-9). Do not disconnect cables (4 and 5).
11.
Unhook governor cable (4) and accelerator cable (5) from the governor arm (7).
1
3059
Figure 24-6 Governor Arm, Cable and Brackets
12.
Disconnect brake cables from brake assemblies. See Wheel Brake Assemblies section.
13.
Remove lower shock mounting hardware from both rear shocks (Figure 24-7, Page 24-9).
1
767
Figure 24-7 Disconnect Shock Absorbers
2016 Precedent Golf Car Maintenance and Service Manual
24
Transaxle Removal
Page 24-9
Advertisement
Table of Contents
Troubleshooting
