Table of Contents
Advertisement
ELECTRICAL COMPONENTS – SUBARU EX40
KEY SWITCH INSTALLATION
1.
Reverse removal procedures to install key switch in the instrument panel. Connect wires to key switch.
2.
Install the instrument panel.
2.1.
Connect the electrical connector (3) (Figure 19-21, Page 19-20).
2.2.
Position the instrument panel (2) on the dash assembly. Make sure tabs on upper edge properly engage
with the corresponding slots on the dash assembly. Ensure that there are no wires exposed or pinched
during positioning.
2.3.
Secure instrument panel to the dash assembly with three screws (1). Tighten screws to 1.8 ft·lb (2.5 N·m).
3.
Connect battery and spark plug wire(s). See Side-Post Battery: Connecting the Battery-Gasoline Vehicles
on page 1-3.
See Top-Post Battery: Connecting the Battery- Gasoline Vehicles on page 1-4.
MAINTENANCE/OPERATE SWITCH
TESTING THE MAINTENANCE/OPERATE SWITCH
See Test Procedure 9 – Maintenance/Operate Switch – Pedal-Start Vehicles on page 18-28.
MAINTENANCE/OPERATE SWITCH REMOVAL
1.
Disconnect the battery and spark plug wire(s). See Side-Post Battery: Disconnecting the Battery-Gasoline
Vehicles on page 1-3.
2.
Using a 5/8 inch (16 mm) wrench, remove maintenance/operate boot/hex nut.
3.
Remove maintenance/operate switch from bracket.
4.
Disconnect the three spade terminals and remove switch.
MAINTENANCE/OPERATE SWITCH INSTALLATION
1.
Connect the three spade terminals (Figure 18-12, Page 18-28).
2.
Make sure groove switch is aligned with tang on bracket and install switch. Tighten maintenance/operate switch
boot/hex nut to 16 in·lb (1.8 N·m).
3.
Connect the battery. See Side-Post Battery: Connecting the Battery-Gasoline Vehicles on page 1-3.
2016 Precedent Golf Car Maintenance and Service Manual
Maintenance/Operate Switch
19
Page 19-21
Advertisement
Table of Contents
Troubleshooting
