Table of Contents
Advertisement
4
Rear Body – Two-Passenger Vehicles
621
Figure 4-9 Universal Accessory Mounting
SEAT BACK AND STRUCTURAL ACCESSORY MODULE (SAM)
SAM Removal
1.
If the vehicle has a canopy, the rear upright supports must be removed from the SAM.
2.
Remove four bolts (4) to release the SAM (3) from the vehicle (Figure 4-10, Page 4-13).
SAM Installation
Position the SAM (3) over its mounting holes and secure with four screws (4). Tighten screws to 71 in·lb (8 N·m).
Seat Back
The seat back (1) is secured to the SAM (3) with two screws (2) (Figure 4-10, Page 4-13). When replacing the
backrest, tighten screws (2) to 51 in·lb (5.8 N·m).
Bag Rack Removal
1.
Remove two screws (10) to release the bag hoop (6) and related components from the SAM (3) (Figure 4-10,
Page 4-13).
2.
Bag strap (8) may be released by removing two plastic barrel connectors (9) and one screw (12).
3.
Bag strap buckles (7) may be snapped out of bag hoop (6).
Bag Rack Installation
Installation is the reverse of removal. Tighten screw (12) to 31 in·lb (3.5 N·m) and screws (10) to 53 in·lb (6 N·m).
Sweater Basket
The sweater basket (11) is secured to the bag hoop assembly by three screws (12). Tabs on the upper edge of the
basket align with holes in the bag hoop (6) for installation purposes. Tighten screws (12) to 31 in·lb (3.5 N·m) for
molded-plastic sweater basket (Figure 4-10, Page 4-13).
Page 4-12
2016 Precedent Golf Car Maintenance and Service Manual
1
BODY AND TRIM
Advertisement
Table of Contents
Troubleshooting
